Cabinet Installation GuideIMPORTANT: To reduce the risk of serious or fatal injury, read and understand this entire guide before beginning any instal
6.5 Fasten the cabinet to the wall with #10 x 21⁄2” wall attachment (pan head) screws. 6.6 If there is a blind corner cabinet, seal the opening with
NOTE: CROWN MOLDINGS AND OTHER TRIM MAKE ANY KITCHEN LOOK CUSTOM BUILT. IF YOU ARE NOT AN EXPERIENCED CARPENTER, THIS MAY BE DIFFICULT AND BETTER LEFT
DIAGRAM C: MITER CUTS FOR 90º ANGLESInside Corner Outside CornerLeft SideRight SideLeft SideRight SideMiter right at 45ºSave right end of cutMiter lef
DIAGRAM FMOLDING CUTS90º ANGLES: CUT MOLDING AT 45º ANGLE135º ANGLES: CUT MOLDING AT 22.5º ANGLE158º ANGLES: CUT MOLDING AT AN 11º ANGLEDIAGRAM G 8.1
Door Hinge AdjustmentAll hinges come pre-set from the factory. But occasionally, other adjustments are needed to straighten cocked doors or doors that
Drawer InstallationTo install drawers with Full Access Hidden Glides, extend each drawer glide. Place the drawer on top of the extended drawer glides.
Drawer RemovalTo remove drawers with Full Access Hidden Glides, locate the black plastic clips on the bottom of the drawer. Grasp clips at the finger
10-0533 7/08These insTrucTions should only be prinTed using Adobe AcrobAT And should noT be fAxed or reproduced on A digiTAl copier.
A Brand New Kitchen? Better Start Collecting Some Takeout Menus!So you’ve finally decided to do it—install your own kitchen cabinets. Are you starti
Before You Get Started…If you’re planning to do it yourself, first ask yourself a few questions. 1 Do you have some experience with carpentry? 2 Do yo
1.2 Measure up from the high point 341⁄2” and draw a level line across the wall to establish the top of the base cabinets. If installing cabinets bef
1.4 Now measure up from the wall cabinet base line the same distance as the height of your cabinets (301⁄8”, 361⁄8” or 421⁄8”). This will be the top
NOTE: A BLIND WALL CABINET FILLS THE VOID OF THE CORNER WITH USABLE STORAGE. THE DOOR COMES PRE-MOUNTED ON THE LEFT SIDE, BUT CAN BE MOVED TO THE RIGH
Step 3 Hang the Wall Cabinets One at a Time 3.1 Recheck the pre-assembled cabinets for level and plumb, then disassemble wall cabinets before install
Step 4 Install Fillers (where applicable) 3.7 If there is a blind corner cabinet, the opening should be sealed at this point with the 1⁄8” panel pack
Step 5 Install End Panels (where applicable)WARNINGTO REDUCE THE RISK OF DEATH OR SERIOUS PERSONAL INJURY OR PROPERTY DAMAGE, AVOID ANY CONTACT WITH
Commenti su questo manuale